Filter
Top Products
The Integrated Answering Device
28
You hear a confirmation tone. Then the
announcement “Time” and the day and time are
announced for your review. After a few seconds, the
system announces “To set security code, press
menu again”.
Setting a Personal Security Code (PIN)
To play your messages from a remote location, you
need to enter a two-digit Personal Identification
Number (PIN) code (01-99). To select a PIN,
perform the following steps: Ô
1. Press
MENU/CLOCK twice in standby mode.
“Security code” and the current PIN code is
announced as it is displayed on the base.
Then the system announces the guidance for
setting the PIN code.
2. Press
/VOL/SEL or /VOL/SEL until the
desired number appears.
3. Press
SET to select the PIN code. You hear a
confirmation tone. Then the announcement
“Security code” and the new PIN code is
announced. After a few seconds, the system
announces “To set ring time, press menu
again”.
Setting the Ring Time
The ring time setting allows you to set the number
of rings the caller hears before your answering
system plays the outgoing message. You can set
the ring time to answer after two, four, or six rings.
Set to (Toll Saver) so the answering system
picks up after two rings if you have new messages,
and after four rings if there are none. This way, if
you make a long distance call to check your
messages, you can hang up after the second ring to
avoid billing charges.
Ô NOTE Ô
The PIN code is set to “80”
when you purchase your
phone.
43-3857.book Page 28 Wednesday, February 18, 2004 12:40 PM