Filter
Top Products
Memory Dialing
16
If You Make a Mistake while Entering
a Name
Use /TONE/< or #/> to move the cursor to the
incorrect character, press
CH/DELETE to erase up to
the wrong entry. Then enter the correct character. To
delete all characters, press and hold CH/DELETE.
For example, to enter John; Ô
1. Pick up the handset. Press
MEM.
2. Enter a number or press
VOL or VOL to
select a memory location number.
3. Press MEM or REMOTE/SELECT.
4. Press
MEM or REMOTE/SELECT. (When there is
information already stored in the selected
memory location,
Edit MemoryXX is
displayed. See “Editing a Stored Name and/or
Phone Number” on page 17.)
5. Press
5 once.
6. Press
6 six times.
7. Press
4 five times.
8. Press
6 five times.
9. When finished, press
MEM or REMOTE/SELECT.
To continue to store the telephone number, proceed
to step 7 under “Storing Phone Numbers and
Names” on page 14.
MAKING CALLS WITH MEMORY
D
IALING
Memory Dialing from Standby Mode
1. Press MEM. The handset displays your
programmed memory locations.
Ô NOTE Ô
If the next character uses
the same number key, you
must press
#/> to move the
cursor over. Otherwise the
next time you press the
number key, it changes the
character that was
previously set.
43-3857.book Page 16 Wednesday, February 18, 2004 12:40 PM