Filter
Top Products
Memory Dialing
14
1. Press
MEM. Select Memory is displayed.
2. Press
VOL or VOL, or enter a number (0-
9) to select the memory location where you
would like to store the number.
3. Press
MEM or REMOTE/SELECT.
4. Press
MEM or REMOTE/SELECT. A cursor
flashes indicating that the display is ready for
the name to be entered.
If Edit MemoryXX appears, the selected
memory location is already stored. Then you
must either edit the entry in this location, delete
the entry in this location, or select
Go Back to
choose another location.
5. To enter a name (up to 13 characters), use
number keys.
• See “Steps for Entering Names and Special
Characters” on page 15.
• Use #/
> and /TONE/< to move the cursor to
the desired location.
• Use
CH/DELETE to delete characters as
needed.
• Press and hold
CH/DELETE to delete all the
characters.
• If a name is not required, go to step 6.
6. Press
MEM or REMOTE/SELECT. Store
Number is displayed.
The cursor flashes indicating that the display is
ready for the number to be entered.
7. Use the number keys to enter the phone
number.
The phone number cannot exceed 20 digits.
43-3857.book Page 14 Wednesday, February 18, 2004 12:40 PM