Filter
Top Products
Installation
10
4. Use the number keys (
0 to 9) or CH/DELETE to
enter the three-digit area code. Ô
5. Press
REMOTE/SELECT. A confirmation tone
sounds and the displayed area code is entered.
6. Press
END or return the handset to the base
unit to complete the setting. The handset
returns to the standby mode.
Choosing the Dial Mode
Most phone systems use tone dialing which sends
standard tones through the phone lines. However,
some phone systems still use pulse dialing such as
in rural areas. The default setting is tone dialing.
Depending on your dialing system, set the mode as
follows:
Ô
1. When the phone is in the standby mode, press
and hold
CID/MENU.
2. Press
VOL three times to select Dial.
3. Press
REMOTE/SELECT to toggle between
Tone and Pulse.
4. Press
END or return the handset to the base
unit to complete the setting. The handset
returns to the standby mode.
Setting the Language
1. When the phone is in the standby mode, press
and hold
CID/MENU.
2. Press
VOL four times to select Language.
3. Press
REMOTE/SELECT to select from Eng
(English),
Fr. (French) and Esp (Spanish).
4. Press
END or return the handset to the base
unit to complete the setting. The handset
returns to the standby mode.
Ô NOTES Ô
Entering your Area Code
When the area code has
already been stored in
memory, the stored area
code will be displayed. To
change it, use the
CH/
DELETE
and number keys
to enter the new area code.
Then press
REMOTE/
SELECT
. A confirmation
tone sounds.
To complete the setting,
press
END or return the
handset to the base unit.
Choosing the Dial Mode
• Make sure your battery
pack is fully charged
before choosing the
dialing mode.
• If you are not sure of
your dialing system,
make a trial call. If the
call connects, leave the
setting as is, otherwise
set for pulse dialing.
• If your phone system
requires pulse dialing
and you need to send
the standard tones for
certain situations during
a call, you may “switch-
over” to tone dialing
(Refer to “Tone Dialing
Switch-over” on page
12).
43-3857.book Page 10 Wednesday, February 18, 2004 12:40 PM