Filter
Top Products
The Integrated Answering Device
27
- (PLAY/STOP) is pressed
- Ten seconds elapse without a key press
- An incoming call is received
• If the system remains idle for about five
seconds after the announcement, the system
returns to standby. Once or
/VOL/SEL is
pressed, the idle time is extended to ten
seconds.
Setting the Time
The clock on the answering system starts when
power is supplied to the base. Follow these steps to
set the clock to the correct time. Ô
1. Press
MENU/CLOCK.
The system announces “Time”, the current time
and the guidance for setting the time.
2. Press
/VOL/SEL or /VOL/SEL until the
correct day is announced. The numbers [ ]
through [ ] are displayed on the base.
3. Press
SET to select the day.
4. Press
/VOL/SEL or /VOL/SEL until you hear
the correct hour setting. The numbers [ ]
through [ ] are displayed on the base.
5. Press
SET to select the hour.
6. Press
/VOL/SEL or /VOL/SEL until you hear
the correct minute setting. The numbers [ ]
through [ ] are displayed on the base.
7. Press
SET to select the minute.
8. Press
/VOL/SEL or /VOL/SEL until you hear
the correct AM or PM setting. The message
counter displays [ ] or [ ].
9. Press
SET to select the AM/PM setting.
Ô NOTES Ô
• Normally the idle time for
the menu mode is ten
seconds before the
system returns to
standby. However for
setting the time, the idle
time is extended to two
minutes.
• Press and hold
/VOL/
SEL
or /VOL/SEL to
quickly scroll through the
numbers on the display.
43-3857.book Page 27 Wednesday, February 18, 2004 12:40 PM