Filter
Top Products
Viewing People and Content
3–5
RPX 200
Series
ATX 300
System
Typically, four seats on the right display.
The left display is blank. This may differ
depending on how the integrator set up
the ATX room.
The entire RPX suite. Two seats are
shown on the left display and two seats
are shown on the center display. The
right display is blank.
RPX 200
Series
Traditional
(standalone)
video
conferencing
system
(such as a
Polycom
HDX
system)
The people at the far site on the right
display. The left display is blank.
The right two seats at the RPX main
table.
RPX 400
or 200
Series
More than
one other
site
(multipoint
call)
In multipoint calls, what you see and what the far site sees depends on a variety of
factors including the number of sites in the call, the types of systems in the call, the
cameras being used, and so forth. If a site is using the VNOC, the VNOC operator
usually configures the layout so that every site sees all the other sites in the call.
The following illustrations show what you might see with one RPX 400 Series, one
RPX 200 Series, and one TPX 306M system, Version 2.0 (with EagleEye HD 1080i
cameras) in a multipoint call.
This is the view from the RPX 400 suite:
This is the view from the RPX 200 suite:
If you
make a
call
between
an...
And a/an...
This is what you will see in your RPX
suite...
This is what the far site will see...
HDX