Filter
Top Products
Polycom Immersive Telepresence (ITP) User’s Guide
2–20
Placing a Call Using Meeting Composer
Once you have added the sites you want to call to the Conference List on the
right side of the Meeting Composer screen, you can make the call to those sites
as described in this section.
If your system is configured to use the Polycom RMX, you can make a call to
multiple sites as well as to Immersive Telepresence sites. You can select up to
30 sites to dial at once (in any combination of single and multipoint sites). After
the conference has started, you can add additional sites or drop sites. The
maximum number you can add is determined by the available resources on
the Polycom RMX.
Note that if you create a Conference List of only one site and that site is not a
multipoint site or a SIP endpoint, the system will make the call as a
point-to-point call without using the RMX.
To place a call using Meeting Composer:
1 Ensure that the sites listed in the Conference List include all the sites you
want to call:
— If you want to delete a site, touch
Delete next to the entry.
— If you want to cancel the call and delete all of the sites, touch
Cancel.
— If you want to add another site, refer to Selecting Sites Using Meeting
Composer on page 2-13.
2 Touch
Join to begin the conference.
The Call screen appears.
Figure 2-23 Call Screen (In an OTX 300 Call)