Filter
Top Products
21
20
3.6 Parking
You can “park” a call. The connection still remains.
There are two ways to resume the call:
1. You pull the plug of the telephone at the telephone connection socket in
order to plug it into another socket (of the same multi-device line). You
can then resume the call there.
2. You can also resume the call at another SmartLine D750 operating at the
same ISDN line.
A – Telephone operation: 4 Comfort functions
3.4 Brokering
You can set up a 2nd call during a telephone call so that you can talk
alternately with both of the other parties (= brokering). During brokering, the
party that you are not talking to at that moment is put ”on hold”. He/she
cannot hear the other conversation.
You are in the middle of a telephone call:
- Dial telephone number - When you are connected with
the 2nd party:
By repeatedly pressing the consultation key, you
can switch between the two connections.
End brokering:
press disconnect key
You are reconnected with the party you previously put on hold
Note
3.5 Conference
You can set up a 2nd call during a telephone call so that you can
subsequently talk with both parties at the same time. For this, the ISDN
function ”three-party conference” must be available for your line.
You are in the middle of a telephone call:
If one of the parties you are talking to ends the call, you remain connected
with the other one.
- Dial tel. number - When you are connected with the 2nd
party:
-
end conference:
A – Telephone operation: 3 Telephoning: During a call
Viewing the call list / deleting an entry
If list entries are available,
is displayed in idle condition:
Viewing the list
Deleting an entry
4.1 Call list
Certain calls with transfer of the telephone number can be automatically
stored in the call list:
1. Not accepted calls (also applies when the capacity of the
answering device has been reached).
2. Camp-on busy calls which were refused.
A maximum of 10 calls are stored along with telephone number and the
message sent. With more than 10 calls the oldest entry is replaced by the
next incoming call.
( )
- -
display of the last caller
select input
read : date, time, number of calls
Select display of a Message (if present), or called MSN
Confirm
Or: - Confirm erase
The parking period must not exceed 3 minutes.
Resumption of the call can also be performed without previously lifting the
handset. The unit then automatically switches hands-free operation on.
Parking a call
You are in the middle of a call ( )
-
You can input a code (maximum 2 digits) for the connection .
The input is, however, not necessary.
Confirm storage
You can resume the call connection within 3 minutes.
Resuming the call
Notes
– ( )
–
Only if parking was performed using a code number:
Enter code (maximum 2 digits) ,
Confirm storage