Filter
Top Products
17
16
Identification
with outgoing
calls
Identification
with incoming
calls
A – Telephone operation: 2 Telephoning: Basic functions
-
or
switch on or off – store setting
-
-
or
switch on or off - store setting
2.9 Identifying
”Identifying” is the transfer and display of your own telephone number on
the telephone of the other party. Y
our telephone number can be transferred:
1. If you call someone yourself (identification with outgoing calls).
2. If you are called, as soon as you accept the call (identification for
incoming calls). The caller can read your telephone number in his/her
display (assuming the caller’s telephone has a display). This can be very
important in cases where the call has been diverted.
When ordering an ISDN line, you can specify whether the telephone
number display transfer should always be suppressed or not.
Prerequisite for changing over the identification:
1. Telephone number transfer must be available for your ISDN line.
2. The ISDN function ”selective identification changeover” must be
available as a feature for your line. This changeover facility must then be
activated as an additional feature at your SmartLine D750 (see 5.12:
Additional function”Identification changeover”).
Once you have performed the settings, you can use the changeover facili-
ties described here (identification off = suppression of telephone number
transfer). The changeovers can be used differently for incoming and out-
going calls.
2.9.1 Basic setting
You can set the transfer of your telephone number (= identification) to be
always on or off (on delivery: switched on). For the prerequisites for this
feature, please refer to the previous section. The menus described here are
only offered when these prerequisites are fulfilled.
A – Telephone operation: 2 Telephoning: Basic functions
Camp-on busy:
Switching
authorisation
on and off
The caller hears the a ringing tone. If the answering device is switched on, it
takes the call
You are in the middle of a call. A 2nd call is signalled:Rejecting
a call
-
call is offered
-
Rejecting a call
You can also end the 1st call by replacing the handset. The camp-on call is
then signalled as a normal telephone call.
Accepting
a call
- call is offered -
Accept call
You are connected with the caller, the 1st call is put on hold.
End the 2nd call:
press the disconnect key
You are reconnected with the first party.
2.10 Camp-on busy (COB)
Another incoming call during a telephone call is signalled to you acoustically
by the camp-on busy tone. You can accept or reject the call. You can switch
the authorisation for camp-on busy on or off (on delivery: on).
You are in the middle of a call. A 2nd call is signalled:
-
-
or
Switch on or off – store setting
2.9.2 Temporary identification changeover
Identification can be changed over temporarily (for the following call). The
basic setting (see 2.9.1) is not altered by this.
The above mentioned prerequisites also apply for temporary identification
changeover.
You receive a call: Switch over before taking the call.
You wish to make a call: Switch over before dialing the telephone number.
The following is offered in the display (if necessary, select using the cursor
keys):
•
” ” with basic setting identification = On. or:
•
” ” with basic setting identification = Off.
Press the O.K. key to temporarily change over identification.
If identification was changed over prior to manual dialing, this changeover is
also transferred to the number redial memory.