Filter
Top Products
1.21 E1 Line Service Features (KX-TDA100/KX-TDA200 only)
202 Feature Guide
[Explanation]
Conditions
• If an E1 line is used as a trunk, the channel type depends on the contract with the
telephone company.
• If "MFC-R2" is selected as the Dial Mode, the PBX always sends a dial tone, instead of the
telephone company, when making a trunk call using E1 line.
Number in
the table
Feature Description
(1) TIE Line Service Refer to the TIE Line Service feature. ( 1.28.1 TIE Line
Service)
(2) Direct Inward
Dialling (DID)
Refer to the DID feature. ( 1.1.1.3 Direct Inward Dialling
(DID)/Direct Dialling In (DDI))
(3) Direct In Line
(DIL)
Refer to the DIL feature. ( 1.1.1.2 Direct In Line (DIL))
(4) Automatic
Number
Identification
(ANI)
Outgoing ANI:
Sends the caller’s number to the E1 line. The sending
method is the same as ISDN CLIP service. ( 1.20.1.2
Calling/Connected Line Identification Presentation (CLIP/
COLP))
Incoming ANI:
Receives the caller’s number from the E1 line.
When the ANI number is received, it can be treated the
same as a Caller ID number. ( 1.17.1 Caller ID)
(5) Call Charge
Information
The call charge meter pulses can be received during a
conversation. ( 1.25.2 Charge Meter)