Filter
Top Products
9
Browser Operation
Connecting the Center Module
via a PC
1 Launch the PC’s Web browser.
2 Input the Center Module IP address into the
address bar of the Web browser.
Example) http://Center Module IP address
This unit has the following default settings as
the time of shipment:
IP address: 192.168.0.50
Port number: 80
Protocol: http
If the HTTP port number has changed from “80”, input
[http://Center Module IP address: port number] into
the [Address bar].
Example) If the port number is set to 8080:
http://192.168.0.50:8080
Important
3 When a connection has been established
between the Center Module and the PC, an
authentication pop-up screen will appear. Input
the username and password.
The following are the default setting username and
password:
Username: admin
Password:
12345
If authentication is successful, the operation screen
will appear.
The IP address of the Center Module can be checked
on the Center Module screen. For details, refer to the
Operating Instructions <Installation Guide>.
Note
Be sure to change the username and password to
ensure that the system is secure. For details, see
“Configuring server settings” (p. 13).
Important
Setup Instructions
This section describes basic operation procedures to set
this unit with browser operations.
1
2
1 Input the necessary information into the
settings.
2 Click the [Set] button.
The settings will not be reflected unless the [Set]
button is clicked.
Do not click the button repeatedly. Doing so may
result in the settings being set incorrectly.
Important
WX-CC411_PGQP1741ZA_BG_en.indd 9 2014/01/17 15:17:35