Filter
Top Products
13
Browser Operation
UPnP
The Center Module is compatible with UPnP (Universal
Plug and Play). Using UPnP function, you can configure the
following settings automatically.
Set the router port forwarding function. (A router that is
compatible with UPnP is required.) This setting is useful for
accessing the Center Module via the Internet.
[Auto port forwarding]
Set whether or not to use the router’s port forwarding
function with the ON and OFF radio buttons. To use the auto
port forwarding function, the router being used must be the
UPnP compatible and UPnP function must be enabled.
Default setting: OFF
Auto port forwarding may change the port number.
If the port number has been changed, the Center
Module port number registered to the PC must also
be changed.
To check if auto port forwarding has been set
correctly, click the [Status] tab of the [Maintenance]
button in the Setup menu panel and confirm that the
[UPnP] status is [Enabled].
Note
If UPnP settings are altered, the Center Module will
restart automatically.
When changing port forwarding settings, check the
status of the router using the Operating Instructions
for the router.
Important
Configuring server settings [Server]
This function is used to configure the settings of the server
connected to the Center Module.
Click the [Installation] button, then the [Server] tab.
NTP
Configure the NTP server settings, such as the NTP server
address and port number.
If a more accurate time setting is needed for system
operation, use the NTP server.
Important
[Default] button
This button is used to restore the NTP settings to the default
settings.
[Time adjust]
Set whether or not to retrieve the time from the NTP server.
ON: Synchronize with the NTP server and automatically
adjust the date and time of the Center Module.
OFF: Do not synchronize with the NTP server.
Default setting: OFF
[NTP server address (Manual / Auto)]
When [ON] is selected for [Time adjust], a method for
retrieving the NTP address must be selected.
Manual: Input the NTP server address into the [NTP server
address] to set.
Auto: Retrieve the NTP server address from the DHCP
server.
Default setting: Manual
When retrieving the “NTP server address” from the
DHCP server, the DHCP function must be enabled
through operations on the Center Module.
Important
WX-CC411_PGQP1741ZA_BG_en.indd 13 2014/01/17 15:17:38