Filter
Top Products
26
Browser Operation
The SMTP server must be set before an email can be
sent. To set the SMTP server, click the [Installation]
button, then the [Server] tab.
The following substitute characters can be used in the
email body. The substitute characters will be replaced
with the corresponding character string when the
email is sent.
Note
Substitute
characters
Character string after substitution
%d% Date of alert
e.g. 05
%M% Month of alert (alphabetical character)
e.g. Feb
%m% Month of alert (numerical character)
e.g. 02
%Y% Year of alert (four-digit)
e.g. 2014
%y% Year of alert (the last two digits)
e.g. 14
%t% Time of alert
e.g. 15:00:00
%a% Status of alert
When an alert starts: Alert Happened
When an alert ends: Alert Stopped
%p% Origin of alert
Alert terminal: Alert Input* (* is the terminal
number)
All-In-One Headsets and Belt Packs: “Headset”
%i% IP address of the Center Module
%s% Information entered in Site Information
Mail for Alert * (*: 1 to 4)
Set the details of the e-mail to be sent when a security alert
occurs from an alert input and when the alert ends. For
setting details see, “Mail for F button”.
Confirming the remaining
capacity and the total capacity
of the SD card
This tab is used to confirm the total capacity and remaining
capacity on an SD card inserted into the Center Module.
To display this screen, click the [SD memory card] button in
the Setup menu panel.
[Remaining capacity]
Displays the remaining capacity of the SD card. Displayed
as “Remaining capacity / Total capacity”.
If there is no SD card inserted, this field displays
“--------KB/--------KB”.
WX-CC411_PGQP1741ZA_BG_en.indd 26 2014/01/17 15:17:43