Filter
Top Products
25
Browser Operation
Confirming the security alert
settings
This screen is used to confirm the operations to be
performed when a security alert notice is received from
button F of an All-In-One Headset or Belt Pack or from alert
inputs 1 to 4.
To display this screen, click the [Security alert] button in the
Setup menu panel.
List of alerts
Displays the types of security alerts and the operations to
perform in the event of a security alert.
[Trigger] column
Displays the types of security alerts.
[Message] column
Displays the alert message to be played during each type
of security alert. This setting can be changed through
operations on the Center Module.
OFF: The alert message is not played back.
Message number
: The alert message is played back.
[Camera monitor] column
Displays the number of the Network Camera that is
displayed on the LCD display during each type of security
alert. This setting can be changed through operations on the
Center Module.
OFF: The image of the Network Camera is not
displayed on the LCD display.
Camera number: The image of the Network Camera is
displayed on the LCD display.
[Device control] column
Displays whether or not to control external control outputs
during each type of security alert. This setting can be
changed through operations on the Center Module.
OFF: External control outputs are not controlled.
ON: External control outputs are controlled.
[Audio recording] column
Displays whether or not to record communications onto the
SD card when a security alert notice is received from button
F of an All-In-One Headset or Belt Pack. This setting can be
changed through operations on the Center Module.
OFF: Communications are not recorded.
ON: Communications are recorded.
[Alert input delay time] column
Displays the delay time until sounding a security alert
from alert inputs 1 to 4. Can be set from 0 to 29 minutes
59 seconds in increments of 1 second.
[E-mail] column
Set whether or not to send an e-mail when each security
alert occurs and ends.
ON: An e-mail will be sent based on the e-mail settings for
the alert occurrence and end of alert.
OFF: An e-mail will not be sent for the alert occurrence and
end of alert.
Default setting: OFF
Mail for F button
Set the details of the e-mail to be sent when a security alert
occurs from button F of an All-In-One Headset or Belt Pack
and when the alert ends. This is enabled when an e-mail
is set to be sent upon receiving button F of an All-In-One
Headset or Belt Pack in the list of alerts.
[Destination E-mail address]
Set the destination email addresses. The same message
can be sent to up to 5 email addresses.
Number of characters: 3 to 128
Types of characters: alphanumeric, characters @ . _ -
[E-mail subject]
Input the subject of the email.
Number of characters: 0 to 50
[E-mail body]
Input the body of the email.
Number of characters: 0 to 200
WX-CC411_PGQP1741ZA_BG_en.indd 25 2014/01/17 15:17:43