Filter
Top Products
29
Browser Operation
Check the [HTTP Status] / [HTTPS Status] after 10 minutes have passed since starting up the router and Center Module.
The following chart shows the meaning and action to take for each port forwarding [HTTP Status] / [HTTPS Status].
Important
Message Meaning Action
— (no message) Connected without port forwarding. To change the connection type, click the [Installation] button,
then the [Network] tab and set the connection type.
Disabled Internet publishing has not been set up
for a Center Module that is using the
router UPnP function.
Click the [Installation] button, then the [Network] tab and set
“Auto port forwarding” to “ON” in “UPnP”.
Enabled Internet publishing has been set up
properly for a Center Module that is
using the router UPnP function.
—
Setting Automatic port forwarding is being set
up for a Center Module that is using the
router UPnP function.
Wait for the router to finish setting up.
Deleting After disabling automatic port
forwarding for a Center Module that
is using the router UPnP function, the
UPnP settings of the router are being
deleted.
Wait for the system to finish deleting the router UPnP settings.
Failed to set The router is not UPnP compatible, or
the UPnP function has not been set.
The UPnP function of the router has been disabled.
Refer to the instruction manual for the router to enable the
UPnP function.
The router does not have a UPnP function.
Set port forwarding according to the instruction manual for the
router.
The power for the router has been turned off.
Turn on the power for the router, then restart the Center
Module.
If the network status for the Center Module reads “Static”,
the network settings are incorrect.
Confirm the default gateway and subnet mask settings for the
Center Module network.
Some routers may not work with the Center Module, even
if they are UPnP compatible and have been enabled,
because they are not compatible with the Center Module. In
such cases, set port forwarding according to the instruction
manual for the router.
Failed to delete After changing to a setting where
Internet publishing is not set for a
Center Module that is using the router
UPnP function, the system failed to
delete the UPnP settings of the router.
[Reboot]
Clicking the [Reboot] button restarts the Center Module.
When the Center Module is rebooted from a browser, the Center Module will restart without displaying a warning on the
LCD display. Be sure to check the operational status before rebooting from a browser.
Important
WX-CC411_PGQP1741ZA_BG_en.indd 29 2014/01/17 15:17:44