Filter
Top Products
14
Browser Operation
[NTP server address]
If “Manual” is selected for [NTP server address (Manual
/ Auto)], enter the NTP server IP address or host name
manually.
Number of characters: 1 to 128
Types of characters: alphanumeric, characters -.
Default setting: None (blank)
When entering the host name into the “NTP server
address”, the DNS setting must be configured on the
[Network] tab of the [Installation] button on the Setup
menu panel.
Important
[NTP port]
Input the NTP server port number.
Settable port numbers: 1 to 65535
Default setting: 123
The following port numbers cannot be used.
(Excluding the port number set in the default settings.)
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161,
162, 443, 995, 10669, 10670
Important
[Time adjustment interval time]
Select the interval for retrieving the time from the NTP
server (1 hour units, from 1 to 24 hours).
Default setting: 1h
[Time zone]
Select the time zone corresponding to the region in which
this unit is being used.
Default setting: GMT-06:00 Central Standard Time
SMTP
Configure the settings of the email server for sending emails
from the Center Module.
[Default] button
This button is used to restore the SMTP settings to the
default settings.
[SMTP server address]
Input the IP address or host name of the SMTP server for
sending email.
Number of characters: 1 to 128
Types of characters: alphanumeric, characters -.
Default setting: None (blank)
[SMTP server port]
Input the port number for sending email.
Settable port numbers: 1 to 65535
Default setting: 25
The following port numbers cannot be used.
(Excluding the port number set in the default settings.)
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161,
162, 443, 995, 10669, 10670
Important
[Authentication]
Type
Select one of the following authentication methods for
sending email.
None: No authentication
POP before SMTP:
Authenticate the POP servers for
receiving email before sending email.
SMTP: Authenticate the SMTP server.
Default setting: None
If unsure of which authentication type to use for
sending email, inquire with the system administrator.
Note
User name
Input the username for accessing the server.
Number of characters: 0 to 32
Types of characters: alphanumeric, characters
!#$%'()=˜¦`{}<>?_-^[]/@*,.+
Default setting: None (blank)
User password
Input the password for accessing the server.
Number of characters: 0 to 32
Types of characters: alphanumeric, characters
!#$%'()=˜¦`{}<>?_-^[]/@*,.:;+¥
Default setting: None (blank)
[POP3 server address]
If [POP before SMTP] is selected for [Authentication Type],
input the POP3 server IP address or host name manually.
Number of characters: 1 to 128
Types of characters: alphanumeric, characters -.
Default setting: None (blank)
WX-CC411_PGQP1741ZA_BG_en.indd 14 2014/01/17 15:17:38