Filter
Top Products
73
Useful Information
For assistance, please call: 1-800-211-PANA(7262)
Problem
You cannot program items,
such as the dialing mode.
You cannot store a name
and phone number in the
directory.
While programming or
searching, the handset
starts to ring and stops the
program/search.
The unit does not display
the caller’s name and/or
phone number.
The handset display exits
the Caller List.
Cause & Remedy
•Programming is not possible while the
handset is being used.
•Do not pause for over 60 seconds while
programming.
•Walk closer to the base unit.
•
Ö, Ñ, Ü or á may have been pressed
when you picked up the handset. Press
(OFF)
and try again.
•If more than 3 other users are using the
handsets, you may not be able to program.
Try again later.
•If the 2-Way Radio mode is on, turn it off
(p. 53).
•
You cannot store an item in the directory while
the handset is in the talk, speaker phone,
intercom or Room Monitor mode or 2-Way
Radio mode.
•Do not pause for over 60 seconds while
storing.
•To answer the call, press or . Start
again from the beginning after hanging up.
•You need to subscribe to a Caller ID service.
•
Other telephone equipment may be interfering
with your phone. Disconnect it and try again.
•Other electrical appliances connected to the
same outlet may be interfering with the Caller
ID information.
•Telephone line noise may be affecting the
Caller ID information.
•The caller requested not to send his/her
information. See page 29.
•If a call is being transferred to you, the caller
information will not be displayed.
•Do not pause for over 60 seconds while
searching.