Filter
Top Products
72
Troubleshooting
Problem
The unit does not work.
“No link to base.
Walk closer to
base and try
again.” is displayed and
an alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset and/or the
base unit does not ring.
The handset display is
blank.
Cause & Remedy
•Check the settings (p. 11–12).
•Check whether the dialing mode setting is
correct (p. 16).
•Charge the battery fully (p. 12).
•Clean the charge contacts and charge again
(p. 13).
•Install the battery properly (p. 12).
•Unplug the AC adaptor to reset. Plug in, and
try again.
•The handset has not been registered to the
base unit. Register the handset (p. 21, 68).
•Re-install the battery (p. 66) and charge it
fully.
•You are too far from the base unit.
Walk closer to the base unit and try again.
•Plug in the AC adaptor.
•Raise the base unit antennas.
•Locate the handset and the base unit away
from other electrical appliances (p. 3).
•Walk closer to the base unit.
•Raise the base unit antennas.
•Press
Ü on the handset to turn on the
Reception Booster feature (p. 24).
•The ringer volume is OFF. Set to HIGH or
MEDIUM or LOW (p. 19, 54).
•If more than 3 other users are using the
handsets and base unit, the handset/base
unit may not ring. Those users will hear
incoming call tones (p. 61) and the IN USE
indicator flashes quickly on the base unit.
•Charge the battery fully (p. 12).