Filter
Top Products
Voice Mail Service
56
*
For quick access to your voice mail box by using
the right soft key ( ) on
the handset
or (VM) on the base unit, you may add pauses between your
voice mail box access number and your mail box password in step 5.
EX. 1-222-333-4444 PPPP 8888
Your voice mail box access number Your mail box password
Pauses
Pressing (PAUSE/REDIAL) once creates a 3.5 seconds delay and counts as
one digit. The delay time depends on a telephone company.
MAIL
Setting the Voice Mail (VM) Tone Detection
Your telephone company sends special signals (Voice mail tones) to activate
the VM indicator. Press , or
(DIGITAL!SP-PHONE)
to listen to the dial
tone. If you hear a series of dial tones followed by a continuous dial tone, this
is indication that a new message was recorded. Your phone comes set to
detect these tones (set to “On”). Minutes after you hang up or after the phone
stops ringing, your unit will seize the phone line and check if a message has
been recorded. If a new message was recorded at your telephone company,
“Voice mail” will be displayed on the handset and the base unit VM
indicator will flash.
Set this programming to “Off” when:
—you do not subscribe to a voice mail service,
—your telephone company does not send a series of tones, followed by a
continuous tone, or
—your phone is connected to a business or office telephone system (PBX).
Please refer to below to set this programming to OFF.
If you are not sure which setting is required, consult your local telephone
company or contact Panasonic Customer Call Center.
Make sure the base unit and the handset are not being used.
1
Press (CONF/FUNCTION), and scroll to
“Initial setting” by pressing Ö or
Ñ, and press á.
2
Scroll to “Voice mail” by pressing Ö or
Ñ, and press á.
3
Press á at “VM tone detect”.
•The current setting is displayed.
4
Select “Off” or “On” by pressing Ö or Ñ.
5
Press the right soft key ( ).
•A beep sounds.
•To exit the programming mode, press (OFF).
•You can exit the programming mode any time by pressing (OFF).
SAVE
Copy directory
H
Initial setting
2Way radio mode
VM tone detect
123445678900:On
IH
SAVE
Set tel line
H
Voice mail
Set base unit
---------------
H
VM tone detect
Save VM access#