Filter
Top Products
Useful Information
55
Troubleshooting
If the handset display shows error messages, see “If the Following Appear on
Your Display...” (p. 54) for the Cause & Remedy.
Problem Cause & Remedy
“No link to base. Move
closer to base, try
again.” is displayed and an
alarm tone sounds.
• You are too far from the base unit. Walk
closer to the base unit.
• Confirm the base unit’s AC adaptor is
plugged in.
• Raise the base unit antenna.
• If the above remedies do not solve the
problem, the handset may have lost
communication with the base unit. Register
the handset again (p. 49).
The handset and/or base unit
does not work.
• Check the settings (p. 8–10).
• Check whether the dialing mode setting is
correct (p. 14).
• Fully charge the battery (p. 9).
• Clean the charge contacts and charge again
(p. 10).
• Check battery Installation (p. 9).
• Unplug the base unit’s AC adaptor to reset it.
Plug in, and try again.
• Re-install the battery (p. 9) and fully charge it.
Static, sound cuts in/out,
fades. Interference from other
electrical units.
• Move the handset and base unit away from
other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• If the unit is connected to a telephone line
with DSL service, you may hear noise from
the receiver or speaker during conversations.
We recommend connecting a noise filter
(contact your DSL service provider) to the
telephone line between the unit and the
telephone line jack.
The handset and/or base unit
does not ring.
• The ringer volume is turned off. Set to high,
medium, or low (p. 16, 17).
The handset display is blank. • If the handset display is blank, fully charge
the battery (p. 9).
You cannot program any
function items.
• Programming is not possible while the
handset and/or base unit is being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• When the Dial Lock is turned on (p. 47), you
cannot store the phone number in the phone
book.
PQQX14670ZA.book 55 ページ ２００５年２月２２日 火曜日 午後１２時０分