Filter
Top Products
Special Features
49
Advanced Operation
Re-registering the Handset
If “No link to base. Move closer to base, try again.” is displayed
even when using the handset near the base unit, the handset may have lost
communication with the base unit. You need to re-register the handset to the base
unit.
• Have both the handset and base unit nearby during registration.
• Follow steps 1 and 2 listed below. You have about 1 minute to complete
them.
• If the handset beeps 3 times and “Error!!” is displayed, an error occurred. Try
again from step 1.
• You can stop registration by pressing [OFF] on the handset, and pressing
[LOCATOR/INTERCOM] on the base unit.
1 Base unit:
Press and hold [LOCATOR/INTERCOM] until a beep sounds.
• The CHARGE indicator flashes.
2 Handset:
Press and hold [FLASH/CALL WAIT] until
“Handset Registering” is displayed.
• When registration is complete, a beep sounds
from the handset.
• Wait for 20 seconds after registration is
complete while the handset establishes
communication with the base unit.
Handset & Base Unit
Handset
Registering
Handset [1]
Registered
PQQX14670ZA.book 49 ページ ２００５年２月２２日 火曜日 午後１２時０分