Filter
Top Products
11
Preparation
Programmable Settings
Programming Guidelines
This unit has several programmable functions which can be selected from the
function menu on the display (p. 12).
How to select a function item from the menu
• To go back to the previous menu, press Back, or press Select while
“---(Go back)----” is displayed. If you press this key in the main menu, the
unit will exit programming mode.
• After programming is complete, the display will return to the main menu or the
sub-menu depending on which menu the selected item is located. (See the menu
table on page 12.)
• You can exit programming mode at any time by pressing [OFF].
• If you do not press any buttons for 60 seconds, the handset will exit programming
mode.
• If the unit detects a problem, an error message will be displayed (p. 54) and/or
error beeps will sound.
Make sure the handset and base unit are not being used. The handset
must be operated near the base unit and while off the base unit.
1 Press [MENU].
• The main menu is displayed (p. 12).
2 Scroll to the desired item by pressing [
d
] or
[
B
].
3 Press Select to select the desired item.
4 If the item has a sub-menu, select the menu item (p. 12). Repeat
steps 2 and 3 until the desired item is displayed. If the item has no
sub-menu, go to step 5.
5 Select the desired setting by pressing [
d
] or
[
B
], then press Save to save your setting.
• A confirmation tone will be heard and the setting
will be saved.
6 Press [OFF] to exit programming mode.
Handset
Back Select
[MENU] enters the
function menu.
When “
d
” or “
B
” is
displayed, navigator key
scrolls through the menu.
[OFF] exits
programming.
The soft keys selects the
functions displayed above
each soft key.
Initial setting
Back Select
K
d
BL
Back Select
Back Save
PQQX14670ZA.book 11 ページ ２００５年２月２２日 火曜日 午後１２時０分