Filter
Top Products
Programmable Settings
18
Ringer Tone
You can set the handset and base unit ringers to use one of 7 ringer patterns for
outside calls. “Tone 1” to “Tone 3” are bell ringer patterns. “Melody 1” to “Melody 4”
are melody patterns. The factory preset is “Tone 1”.
• You cannot change the ringer tone for intercom calls.
• If you select one of the melody ringer patterns, the ringer will continue to sound for
several seconds if:
— the caller hangs up before you answer the call, or
— another person answers the call using another phone connected on the same
line.
Handset ringer tone
Base unit ringer tone
(use either the handset or the base unit)
Make sure the base unit is not being used.
1 Press [MENU].
2 Press Select at “Ringer setting”.
3 Scroll to “Ringer tone” by pressing [
d
] or
[
B
], then press Select.
4 Select the desired ringer tone by pressing [
d
]
or [
B
].
• The handset will ring and the ringer tone will
change. If the ringer volume has been turned off,
the handset will not ring (p. 16).
• You can also select the ringer tone by pressing [1]
to [7].
5 Press Save, then press [OFF].
Press VOLUME [<] or [>], then select the desired ringer tone by pressing
[1] to [7].
[1] to [3] : Bell ringer patterns [4] to [7] : Melody patterns
• After pressing VOLUME [<] or [>], the base unit will ring using the current ringer
tone.
• The base unit will ring and the ringer tone will change.
• To stop ringing, press [0].
Handset
Ringer setting
Back Select
K
d
BL
Ringer tone
Back Select
K
d
BL
Ringer tone
1:Tone 1
Back Save
K
d
BL
Base Unit
PQQX14670ZA.book 18 ページ ２００５年２月２２日 火曜日 午後１２時０分