Filter
Top Products
72
Before Requesting Help
Problem
The unit does not work.
The handset does not operate
or ring.
An alarm tone sounds when
you press (Talk).
A busy tone sounds when you
press (Talk).
" " flashes during a
conversation and the call is
disconnected.
Remedy
• Check the settings (p. 12–18).
• Charge the battery fully (p. 14).
• Clean the charge contracts and charge
again (p. 15).
• The handset has been cancelled or the
handset has not been registered.
Register the handset number (p. 48, 66).
• Unplug the AC adaptor and turn the
power OFF to reset. Reconnect the AC
adaptor and turn the power ON. Then try
again.
• Re-install the handset battery and try
again.
• The power is OFF. Turn the power ON
(p. 16).
• You are too far from the base unit. Move
closer and try again.
• Plug in the AC adaptor.
• Raise the base unit antenna.
• If more than one handset is registered,
another handset is in use.
• The handset is out of range.
Move closer to the base unit and make
the call again.
• Make sure that the AC adaptor is
connected.
KX-TCD950E(E)(72~) 98.6.24 7:55 PM Page 72