Filter
Top Products
17
Chapter 1 Preparation
Selecting the Dialling Mode
You can program the dialling mode by using the handset near the base unit.
If you have touch tone service, set to TONE. If rotary or pulse service is used,
set to PULSE. The factory preset is 1 (TONE).
1
Press (Program), then (Intercom).
• " " and " " are displayed.
2
Press .
3
Enter the base unit password.
• The factory preset of the base unit password is
0000. If you have changed the base unit
password (p. 35), enter the new password.
4
Press .
• The current setting is displayed.
5
To select PULSE, press .
OR
To select TONE, press .
6
When finished, press (Program).
• A confirmation tone sounds.
• " " and " " go out.
1
2
1
3
INT
3
- - - -
3
3 I I
3 I 2
Be sure that the power is ON (p. 16) and you are in the stand-by mode.
Ex. PULSE is selected.
• To cancel during programming, press (Program), then start from step 1.
KX-TCD950E(E)(12~22) 98.6.24 7:56 PM Page 17