Messaging
75
E-mail
Select Messaging > Options > Settings > E-mail, or in
the mailbox main view, select
Options > E-mail settings and from the following:
Mailbox in use—Select which mailbox you want to use for
sending e-mail.
Mailboxes—Opens a list of mailboxes that have been
defined. If no mailboxes have been defined, you are
prompted to do so. Select a mailbox to change the
settings:
Mailbox settings
Mailbox name—Enter a descriptive name for the mailbox.
Access point in use (Must be defined)—Select an Internet
access point (IAP) for the mailbox. See "Connection
settings" on page 106.
My e-mail address (Must be defined)—Enter the e-mail
address given to you by your service provider. Replies to
your messages are sent to this address.
Outgoing mail server (Must be defined)—Enter the IP
address or host name of the mail server that sends your
e-mail. You may only be able to use the outgoing server of
your network operator. Contact your service provider for
more details.
Send message—Define how e-mail is sent from the device.
Select Immediately for the device to connect to the
mailbox when you select Send message. Select During
next conn.—E-mail is sent when the connection to the
remote mailbox is available.
User name—Enter your user name, given to you by your
service provider.
Password—Enter your password. If you leave this field
blank, you are prompted for the password when you try to
connect to your remote mailbox.
Incoming mail server (Must be defined)—Enter the IP
address or host name of the mail server that sends your
e-mail.
Mailbox type—Defines the e-mail protocol that your
remote mailbox service provider recommends. The options
are POP3 and IMAP4. This setting can be selected only
once and cannot be changed if you have saved or exited
from the mailbox settings. If you are using the POP3
protocol, e-mail messages are not updated automatically
in online mode. To see the latest e-mail messages, you
must disconnect and make a new connection to your
mailbox.