Filter
Top Products
Listening to Your Messages
You can listen to your messages after you call your mailbox. If you
listen to a message all the way through, NVM-Series will erase or
save it, depending on programming. To override the automatic
erase/save, press SA to save or E to erase the message. If you listen to
only part of a message, NVM-Series leaves it in your mailbox. This
type of message is classified as a "Held" message.
NVM-Series assigns a pre-programmed listen mode to your mailbox.
A listen mode determines the type of messages that play when you
press L to listen. There are four listen modes: New messages, Saved
messages, Held messages, or All messages. By default, NVM-Series
will play all of your messages when you press L to listen. To change
the pre-programmed listen mode, see your System Administrator.
You can, however, override the pre-programmed listen mode, on a per
call basis, right after you call your mailbox or while your messages
are playing. NVM-Series reverts back to using the pre-programmed
listen mode after you hang up. For details on what to press to override
the listen mode, see Using the Listening Options on page 28.
If your NVM-Series system has the Voice Mail Networking Option
and a network message was returned to you for X or Y reason,
NVM-Series will play the following voice prompt before it plays the
returned message:
●
The following network message was returned to you because _____.
To see the list of reasons why a network message can be returned, see
page 41. To find out when it was returned and the system that could
not accept it, press TI during or after the message.
Listening to Messages
27
17600sug05.qxd 3/13/01 12:01 PM Page 27