Filter
Top Products
43
Display Feature Procedures
This section includes the procedures for seven display features you may use with the 8411 voice
terminal equipped with a display. However, note that the display, along with the softkeys and
display control buttons, can also be used for accessing up to 12 softkey features. For procedures
on using the display and softkeys and a list of the features that can be accessed with the softkeys,
see “Using the Display, Softkeys, and Display Control Buttons” earlier in this guide.
Call Information
You may have as many as 10 call appearance buttons. Beginning with the first button in the upper
left hand corner of your faceplate and going down, the display identifies the buttons in the left
column as a through e. The buttons in the right column are identified as f through j. When the
display shows it represents call information for the first call appearance button. The
next button down would be shown as , and so on, continuing through if all
10 of the buttons are used for call appearances.
When you dial an extension, that number is shown then replaced by the called party’s name and
extension.
When a call is received from another extension, the caller’s name is shown; when a call is
received from outside, “OUTSIDE CALL” or a trunk identifier is shown.
a=
b= j=
The display remains in Normal (call-handling) Mode until you activate one of the other display or
softkey features. After using any of these features, return to Normal (call-handling) Mode by
pressing
.
Exit