Filter
Top Products
ʅ
ʅʅ
ʅ aria 130 - DIGITAL KEY TELEPHONE SYSTEM USER GUIDE
19
Wake-up Call
Button Procedures
To register wake-up time,
Press TRANS/PGM button.
Dial 4 1 and 4-digit wake-up time (HHMM) in 24-hour mode.(HH = 00~23, MM = 00~59)
Press HOLD/SAVE button for “one-day” or dial # and HOLD/SAVE button for “until
canceled”. (Confirmation tone is heard.)
Range
The system automatically sends ring signal to a station which registers a wake-up time. There are two kinds of wake-up call,
one is effective for one-day, the other is effective until canceled.
System Features
To cancel wake-up call,
Press TRANS/PGM button and dial 4 2.
Press HOLD/SAVE button. (Confirmation tone is heard.)
Procedures
Range
Each station and speed dial number can be assigned to a name. When names are programmed, you may select a speed dial
number by the stored name.
Button
Using Dial By Name
Press SPEED button twice.
On the display, you will see the following.
DIAL BY NAME
ICM : 1 U_SPD : 2 S_SPD : 3
Select desired type.
1 : Intercom
2 : User (Station Speed Dial)
3 : System (System Speed Dial)
Confirmation tone is heard and you will see the following.
1 : XXXX XXXX XXXXXX
2 : YYYY YYYY YYYYYY
Procedures
Range
Button
Using Dial By Name
Pressing VOLUME button, the cursor will be moved to the next name. When the cursor
points a name or a dial number to call, press HOLD/SAVE button. Then, the stored
number is dialed.
You may enter characters using the code in “Storing Dial by Name”. The LCD will display
the first two names which match your input. (You may delete the last letter of your input by
pressing CALLBK button. And then, the previous matched name is displayed.)
You can see the matched phone number by pressing FLASH button while the name is
displayed (toggle).
Programming Your Name into Display
Button Procedures
Range
You can program your name and people using display phones will see your name instead of your station number.
Press TRANS/PGM button.
Dial 7 4.
Enter your name. (up to 7 letters using the code in “Storing Dial by name.)
Press HOLD/SAVE button.