Filter
Top Products
30
english
Jabra GO 6430 USER MANUAL
7.8 STAYING WITHIN RANGE
The Jabra GO headset supports the following maximum ranges:
- When talking through the Jabra LINK 350 USB Bluetooth® Adapter:
up to 100m
- When talking over Bluetooth® wireless technology Class 2 (most) mobile phones:
up to 25m
In practice, you will probably find the range to be somewhat shorter due to physical obstructions and
electromagnetic interference. Also, if your headset is in power save mode, the range is slightly reduced.
The sound in your headset will slowly deteriorate as you move farther from its Bluetooth® wireless technology
partner; move back into range to restore sound quality. All sound will stop if you move all the way out of range.
If you are talking through the Jabra LINK 350 USB Bluetooth® Adapter, then your call will be kept open for up to
120 seconds after you go out of range and then disconnected. If you are talking trough a mobile phone, then
your call will probably be disconnected the moment you walk out of range.
After moving out of range, the headset will try to reconnect to the lost device periodically — the headset will try
to reconnect every 15 secs up to five times and then every 15 minutes for 5 hours. After that, it gives up to save
power.
Usually, when you turn off a connected Bluetooth® wireless technology device while the headset is turned on,
the headset will react in the same way as if you had simply walked out of range, as described above.
Tip: For optimal performance with a Bluetooth® wireless technology Class 2 mobile phone, wear the
headset and your mobile phone on the same side of your body or within line of sight. In general, you will
get better performance when there are no obstructions between your headset and your mobile phone.
7.9 MICROPHONE NOISE BLACKOUT™
The Jabra GO headset features an advanced, two-microphone Noise Blackout™ system that will help ensure that
your voice will be clear and easy to understand — even when you are sitting in a crowded office or other noisy
environment. It works by using a pair of directional microphones: one facing towards your mouth and one facing
away. These two signals are combined inside the headset, which subtracts the room-noise signal from the voice
signal, leaving only your voice behind when it is sent to your phone.
This system works best when the headset’s microphone is placed as close as possible to your mouth.
7.10 NARROWBAND VS. WIDEBAND AUDIO
The Jabra GO headset supports both wideband and narrowband audio, but uses narrowband by default. In
particular, you should consider using wideband if you listen to music from your PC.
Notes:
- wideband audio is only supported between Jabra GO headset and base for softphones or for streaming
music from a PC.
- wideband audio may slightly reduce the range of your headset
You are able to configure narrowband/wideband operation for each PC and softphone using the Jabra PC Suite.
See the Jabra PC Suite online help for details.