Jabra 6430 Bluetooth Headset User Manual


 
13
english
Jabra GO 6430 USER MANUAL
4.3 PAIRING THE HEADSET WITH YOUR MOBILE PHONE
To use Bluetooth® wireless technology, you must set up the wireless communication between the Jabra GO
headset and your mobile phone by pairing them. Pair the headset manually at any time using the procedure
below.
1. If your headset is currently turned on, turn it off by pressing and holding on its multifunction button for about
4 seconds — until its LED gives four quick flashes and then turns off.
2. Put your (powered-off) headset in pairing mode by pressing and holding on its multifunction button for about
4 seconds — until its LED lights a constant blue.
4 sec.
3. Make sure that Bluetooth® is active on your mobile phone and put your phone into Bluetooth® pairing mode.
The exact procedure for doing this varies by mobile phone manufacturer and model — see your mobile
phone manual for details.
4. Your phone now looks to see if any nearby Bluetooth® wireless technology devices are advertising themselves
for pairing. Use your phone’s controls to identify and select the Jabra GO 6400 device. Your phone may also ask
for the headset’s pass code. The pass code for all Jabra devices is 0000 (four zeros).
Jabra GO
5. Your phone attempts to connect to the headset and then shows you the result of the attempt. If the attempt
fails, please try again. If you are still having trouble, please check your mobile phone documentation and/or
contact technical support for Jabra and/or your mobile phone.