Filter
Top Products
14 - 3
Back Panel
Power Switch
Toggle the power switch to turn the charger on and off.
Power Supply Connector
You attach the power supply to this connector. The universal power supply accepts input
voltages between 90-265 volts.
Supplying Power
The charger must be connected to a power source via the Honeywell power adapter cable so that voltage
is adjusted appropriately.
1. Locate the AC power adapter cable and plug it into the power source.
2. Connect the power cable to the power adapter.
3. Connect the power cable to the supply connector on the back of the charger.
4. Press the power switch to the ON position.
The power LED illuminates green, and the charger performs a self-diagnostic test that lasts
approximately five seconds.
1
2
3
4
Sw
c
O
CHARGE/ANALYZE
0%
ALYZE
LOT 4
TTE
R
Y
PACITY
0%
Power Supply Connector
Power Switch
Status LED