Filter
Top Products
9 - 2 Rev D
11/20/2007
Dolphin® 7600 User’s Guide
Back Panel
Power Supply Connector
Use this connector to attach the power supply to the QuadCharger. The universal power supply accepts input
voltages between 90-265 volts.
Power Switch
Toggle the power switch to turn the QuadCharger on and off.
Supplying Power to the QuadCharger
Use the power adapter cable that comes with the Dolphin QuadCharger so that the input voltage is adjusted appropriately.
1. Locate the AC power adapter cable and plug it into the power source.
2. Connect the power cable to the power adapter.
3. Connect the power cable to the power supply connector on the back of the QuadCharger.
4. Press the power switch to the ON position.
5. The device performs the following power-up diagnostic routine for each slot indicated by the Status LEDs.:
• All ON Orange
• delay (500ms)
•All ON Red
• delay (500ms)
• All ON Green
• delay (500ms)
•All OFF
Power Supply Connector Power Switch