Filter
Top Products
Dolphin® 7600 User’s Guide Rev D
11/20/2007
3 - 13
4. When the access door is open, slide the SD card into the appropriate slot until it clicks into place.
SD cards must be inserted with the label side facing forward (toward the touch screen).
Note: To remove an installed SD card while the access door is open, tap on the edge lightly to unlock the card;
the card will pop out just enough for you to grab its edge and pull it out.
5. Replace the access door and tighten the screws.
The rubber gasket and surrounding O-ring inside the access door are required for 1) proper functioning of the SD card and
2) preserving the environmental rating for water sealing. Do not remove the gasket or the O-ring.
Do NOT resume terminal operation while the access door is open! Operating the terminal while the access door is open
will void the warranty. The access door must be properly sealed before resuming terminal operation. Failure to seal the
access door will void the warranty.
6. Tap the Blue + Backlight keys to resume operation.
7. To verify that the operating system recognizes the new memory card, open Windows Explorer and navigate to My
Device\IPSM\Storage Card.
!