Filter
Top Products
43
•Press the TALK/CALLBACK button to answer
or place a call before using the headset.
CONNECTING THE BELT CLIP
There are two slots, one on each side of
the handset.
•Attach the belt clip by inserting the sides
of the belt clip into the slots. Snap the
ends of the belt clip into place.
TROUBLESHOOTING TIPS
CALLER ID
No Display
• Check or replace the handset batteries.
•Make sure the unit is connected to a non-switched electrical outlet.
Disconnect the unit from the plug and plug it in again.
•You must subscribe to Caller ID service from your local telephone
company to receive CID information.
Caller ID Error Message
• The unit displays this message if it detects anything other than valid
Caller ID information during the silent period after the first ring. This
message indicates the presence of noise on the line.
TELEPHONE
No dial tone
• Check or repeat installation steps:
•Make sure the wall base unit is correctly plugged into the electrical outlet.
Make sure power cords are connected to working electrical outlets.
Make sure the telephone line cord is connected to the telephone line
jacks (at the wall base unit and the wall).
•Disconnect the wall base unit from the wall telephone jack and connect
another phone to the same jack. If there is no dial tone in the second
phone, the problem might be your wiring or local service.
slots for
belt clip
slots for
belt clip