Filter
Top Products
13
NOTE: If your cabinet has glue blocks or other obstructions, cut out
corresponding areas on the template to clear them. Do not cut out or
cut through the screw holes in the template.
CAUTION: We recommend safety glasses be worn while drilling
screw holes to prevent the possibility of eye injury.
2. Drill three 1/4" diameter holes through the underside of the cabinet.
TIP: On wooden cabinets you may want to mark and start the drill
holes with awl or an awl. Be sure to hold the drill very firmly against
the cabinet.
Use masking tape above the hole locations on the inside of the cabinet
shelf to reduce splintering. If installing the unit under a wood cabinet,
you may want to countersink the drilled hole from the INSIDE of the
cabinet. This will eliminate the use of washers and allow the screw
head to be flush with the floor of your cabinet. If you cannot
countersink the holes, use the supplied washers.
3. Remove the template and drill shavings from inside and underneath
the cabinet.
4. If your cabinet does NOT have an overhang, go to Step 5.
If your cabinet HAS an overhang, select the spacer or combination of
spacers, that is equal to the length of the overhang, plus 5/8". The
added 5/8" is to insure adequate space to remove the handset.
Cabinet
overhang
Length of
overhang
plus 5/8”
Washer
Cabinet bottom
Spacers
3/8” Minimum
5/8
Clearance required
for handset access
Unit as correctly
positioned
Select screws that meet
minimum but do not exceed
maximum length
2-1/16”
Maximum