Filter
Top Products
14
5. Insert screws from the INSIDE of the cabinet. If you did not
countersink the drilled holes, position the washers, flat side down, and
place the screws in the holes.
If your cabinet does not have an overhang, go to Step 7.
6. Hold the screw heads down while you push the selected spacers onto
the screws under the cabinet. Be sure to push spacers until they are
firmly against the cabinet bottom and/or fully nested (if more than one
is used).
7. Align the unit under the screws. Hold the screw holes on the top of the
unit against the mounting screws and partially tighten the screws. Do
not fully tighten until all 3 screws are installed.
TIP: Do not fully tighten until all 4 screws are installed.
8. Extend the cord towards an electrical outlet and secure by using the
cord hooks to hold the cord out of the way. For a more attractive
appearance, place the cord hooks at the back edge of the cabinet (on
or next to wall) directly over the electrical outlet to be used.
To attach cord hooks peel off the adhesive on the back of the hooks
and attach to a clean, dry surface on the underside of the cabinet or
back wall.