Filter
Top Products
8.2 Sending LCD Messages
You can set system-supplied messages at your station to be received and
displayed by a calling LCD speakerphone. These messages give the
caller information on your telephone status. Get a list of the available
messages from the attendant and write them on the blank chart on the
next page.
• To turn on a message from your telephone,
1.
Press OPTIONS, then press PROGRAM.
2.
Press NEXT until LCD MESSAGING appears.
2. Select the message you would like to appear in a calling party’s
LCD by pressing the corresponding interactive button. If you
need to scroll through the list of available messages, press the
NEXT button.
If you use the default messages Back at and Call, add to them as
follows:
For Back at message, dial the code for time numbers and colon
from dialing codes table on the next page (for example, dial # 00
01 29 04 05 for the time 01:45).
For Call message, dial code for telephone number of where you’ll
be (for example, dial # 09 07 08 15 02 02 00 00 for the number
978–2200.
3.
Press DONE, then press EXIT to end message.
4. Intercom light flashes.
• To turn off the message and your intercom light,
1.
Press the CLEAR button.
Large Screen Speakerphone Manual 8 – 3
GCA70–349 Sending And Receiving Non-Verbal Messages