Filter
Top Products
7.14 Setting A Do Not Disturb
Condition At Your Station
This feature keeps calls from ringing at your LCD speakerphone and
makes your station appear to be busy to intercom calls. If your installer
has programmed your station to have this feature, you can enable it as
needed.
Generally, callers cannot override this feature. They hear two quick tone
bursts every two seconds when they call a telephone that is set to the do
not disturb mode. However, the installer may program some telephones
with the ability to override a do not disturb condition at another
telephone.
You can program a permanent do not disturb button to provide yourself
with quick access to this feature if you wish. See the programming
section of this user’s guide for details.
• To enable or disable the Do Not Disturb, proceed as follows:
1.
Press OPTIONS, then press PROGRAMMING.
2.
Press the DO NOT DISTURB (to the right of the LCD) to toggle
the Do Not Disturb feature on or off.
3.
Press EXIT.
• To set a do not disturb condition at your telephone when a call rings
at your station,
1. Hear ringing and notice incoming call information in display.
2.
Select DO NOT DISTURB option. Ringing will stop, caller will
hear the do not disturb tone, and your telephone will remain in
DND until you disable the feature (described above).
• To override a do not disturb condition at another telephone, use the
procedure detailed in section 3.10.
7 – 12 Large Screen Speakerphone Manual
Using The Other Telephone Features GCA70–349