Cisco Systems 7985G IP Phone User Manual


 
36 78-16798-02
Using a Headset, and Speakerphone
The table below describes how to use these devices.
If you want to... Then...
Use a headset Press (Headset button) to toggle headset mode on and
off. (AutoAnswer users should see the “Using AutoAnswer with
a Headset or the Speakerphone” section on page 37 for
exceptions.)
You can use the headset in conjunction with all of the controls
on your phone, including
(Volume button) and
(Audio mute button).
See the “Obtaining a Headset” section on page 36 for headset
purchasing information.
Use the speakerphone Press (Speaker button) to toggle speakerphone mode on
or off.
Many of the actions that you can take to dial a number or
answer a call automatically trigger speakerphone mode,
assuming that the handset is in its cradle and the
(Headset button) is not lit.
Switch to the headset or
speakerphone (from the handset)
during a call
Press (Speaker button) or (Headset button); then,
hang up the handset.
Switch to the handset (from the
speakerphone or headset) during a
call
Lift the handset (without pushing any buttons).
Tips
See the “Connecting Your Video Phone” section on page 6 to locate the headset port.
See the “Basic Call Handling” section on page 19 for detailed instructions about how to use the
headset and speaker to place, answer, end, and otherwise handle calls.
Obtaining a Headset
Your phone supports 2.5mm 3-pole headset jacks. For information about purchasing headsets, see
the following URL:
http://www.plantronics.com, products, mobile.