Filter
Top Products
Step−by−Step Instructions
The instructions in this section guide you through the minimum configuration steps that are required to enable
a Cisco 7920 with a static WEP key.
Turn on the Cisco 7920.1.
Choose Menu > Phone Settings > USB Enable / Disable [Enable] to enable the Cisco 7920 USB
port.
2.
Connect the Cisco 7920 to the USB cable. (The USB cable should already be connected to the PC.)3.
Start the Cisco 7920 Configuration Utility on the PC.
Note: If you use Cisco Wireless IP Phone 7920 Firmware Release 2.0, use Cisco 7920 Configuration
Utility 2.0. If you use an earlier firmware version on the phones, then you must use an earlier version
of the Configuration Utility. Cisco 7920 Configuration Utility 2.0 can be download from Cisco 7920
Wireless Phone Software Downloads (
registered customers only
) .
4.
Log in to the Cisco 7920.
The default User Name is Admin. The default Password is cisco. Click OK.
5.
When this popup window appears, click OK:6.
Choose Edit > Settings Wizard.7.