Filter
Top Products
Verifying
There are no steps to verify this part of the configuration. It can be verified at the end of the next subtask.
Troubleshooting
All of the troubleshooting guidelines can be found in the Troubleshooting Guidelines section at the end of this
document.
Configuring the Cisco Aironet 1200 AP with a VLAN
The instructions in this section guide you through the minimum configuration steps to enable VLANs on an
Cisco Aironet 1200 AP. There are two subtasks that must be preformed. The first is to create the VLANs. The
second is to create the additional SSIDs and assign them to the VLANs. In this task, you will create VLAN1
and VLAN2.
Step−by−Step Instructions for Configuring VLAN 1 (default)
The steps in this section describe the process to configure VLAN1 (the default VLAN) on the Cisco Aironet
1200 AP.
Load the Cisco Aironet 1200 AP administration page into your browser with the address
http://1200ap−ip−address .
1.
Before you configure the VLANs, create SSIDs for the VLANs.
In this case, assume that the SSID for VLAN1 and for VLAN2 are created as VLAN1 and
VLAN2. See the previous procedure to create the SSIDs.
Choose Services > VLAN.a.
To create the default VLAN, select <NEW> and set the VLAN ID field to 1.b.
Check the Native VLAN and the appropriate Radio check boxes, and select VLAN1 on the
SSID drop−down list.
c.
Click Apply to save the settings.d.
2.
When this popup warning appears, click OK:3.