Filter
Top Products
If you want the Cisco 7920 to prompt the user for a LEAP password instead of use the password
stored the Cisco 7920s configuration, continue with this step. Otherwise, proceed to the next section
of this document.
On the Cisco 7920, choose Menu > Network Config > 802.11b configuration > LEAP >
prompt Mode > On.
This forces the user to manually enter a password, the next time that the phone needs to
authenticate.
♦
23.
Configuring the Cisco Aironet 1200 AP for LEAP
Note: In this subtask, the menu choices to configure LEAP on the Cisco Aironet 1200 AP are labeled EAP,
not LEAP. The configuration that results will support LEAP authentication for the Cisco 7920.
Load the Cisco Aironet 1200 AP administration page into your browser with the address
http://1200ap−ip−address .
1.
Click Security > Server Manager.
The Server Manager page appears.
Select RADIUS on the Current Server List.a.
Select <NEW> to add the server.b.
In the Server field, enter the IP address of the Cisco Secure ACS (in this case, 10.21.15.10).c.
Enter the Shared Secret key (in this case, 1A2B3C4D5E6F7G8H).
Note: This will be the same key that you use in the Cisco Secure ACS subtask later in this
document.
d.
Click Apply to save the settings.e.
2.
When this popup warning appears, click OK:3.
Configure the EAP Authentication, which is available on the same page.
In the Default Server Priorities area, under EAP Authentication, set the Priority 1 drop−down
list to the IP address of the RADIUS server (in this case, the IP address of the Cisco ACS is
a.
4.