Filter
Top Products
The VLAN1 is not used for the remainder of this document. This subtask is provided here as a
reminder that you must associate an SSID with the default VLAN, if you are using VLANs on the
Cisco Aironet 1200 AP. This is also the native 802.1Q VLAN for the 1200 AP.
Step−by−Step Instructions for Configuring VLAN2
The steps in this section describe the process to configure VLAN2.
Load the Cisco Aironet 1200 AP administration page into your browser with the address
http://1200ap−ip−address .
Choose Services > VLAN.a.
Select <NEW> and set the VLAN ID field to 2.b.
Check the appropriate Radio check box, and select VLAN2 on the SSID drop−down list.c.
Click Apply to save the settings.d.
1.
When this popup warning appears, click OK:2.
Configure the WEP Key for the VLAN2.
Choose Security > Encryption Manager.a.
Select the VLAN ID 2 on the Set Encryption Mode and Keys for VLAN drop−down list.b.
In the Encryption Modes area, click the WEP Encryption radio button, and select
Mandatory.
c.
Click the Encryption Key 1 radio button to set it as the Transmit Key, and enter the same
WEP key that you previously entered in the Cisco 7920 (in this case,
1234567890abcdef0987654321).
d.
3.