Filter
Top Products
When this popup warning appears, click OK:4.
Configure the WEP Key for the VLAN1.
Choose Security > Encryption Manager.a.
Select the VLAN ID 1 on the Set Encryption Mode and Keys for VLAN drop−down list.b.
In the Encryption Modes area, click the WEP Encryption radio button, and select
Mandatory.
c.
Click the Encryption Key 1 radio button to set it as the Transmit Key, and enter the same
WEP key that you previously entered in the Cisco 7920 (in this case,
1234567890abcdef0987654321).
Note: The WEP key input appears as asterisks. This is normal behavior.
For more information on the configuration of WEP keys, refer to Configuring WEP and WEP
Features.
d.
Click Apply to save the settings.e.
5.
When the next popup warning appears, click OK:
Note: This section assumes that you are only using open authentication at this time.
Also, do not select the EAP option.
6.