Filter
Top Products
5. USING THE OPERATION PANEL (BASIC OPERATIONS)
31
BAS-300G, BAS-311G, BAS-326G
3
Press the key.
The sewing machine will switch to intermittent presser foot height
setting mode.
• " 4" will appear in the PROGRAM No. display, and the work
clamp will rise to the setting value that appears in the menu
display.
(Intermittent presser foot height setting: 0.0 − 10.0)
Press the
or key to set the intermittent presser foot
height.
• The intermittent presser foot will rise or drop to the height of
the new value that has been set.
NOTE:
After making the setting, be sure to turn the pulley once by
hand and check that the intermittent presser foot does not
touch the needle bar.
<Changing modes>
Motor-driven work clamp specifications
" 1" Threading mode
↑ ↓
" 2" Work clamp height setting mode
↑ ↓
" 3" Intermediate work clamp height setting mode (*)
↑ ↓
" 4" Intermittent presser foot height setting mode
Pneumatic work clamp specifications
" 1" Threading mode
↑ ↓
" 4" Intermittent presser foot height setting mode
4
Ending setting mode
THREAD/CLAMP indicator switches off
Press the THREAD/CLAMP key.
• The setting values will be memorized.
• The work clamp will return to where it was before setting mode
was started.
Intermittent presser foot operation
1 Intermittent presser foot lift amount
2 Intermittent presser foot height
The settings can be made by the above
operations.
However, set the intermittent presser foot
height to a higher setting than the
intermittent stroke.
* If it is set smaller, the intermittent presser
foot will come into contact with the
needle plate.
3 Intermittent stroke
When making the adjustment, refer to
“10-14. Changing the intermittent stroke” in
the instruction manual CD.
4448Q
5225Q
* When memory switch No. 003 is set to “2”
5033Q
During standby
When lowered
While sewing