Filter
Top Products
5. USING THE OPERATION PANEL (BASIC OPERATIONS)
27
BAS-300G, BAS-311G, BAS-326G
5-2. Loading sewing data
Refer to "5-8. Notes on handling CF cards (sold separately)" for details on using CF cards.
1
With the power turned off, insert the CF card into the CF
slot.
NOTE:
• Make sure the CF card is facing the correct way
when inserting it.
• Always be sure to keep the cover closed except
when inserting and removing the CF card. If this is
not done, dust may get inside and cause problems
with operation.
2
CF media indicator illuminates
Turn on the power switch.
Press the or key to select the program number
(100 − 999).
* The "---" display is used to check the feed home
position.
3
Loading
Press the R/W key.
• The buzzer will sound and the selected sewing data
will be loaded from the CF card and copied into the
sewing machine's internal memory.
4
Loading complete
The PROGRAM No. display will change from " P" to the selected program number.
Turn off the power switch, remove the CF card, and then close the cover of the CF slot.
5-3. Setting the program number
1. Press the or key (1) to select the program number
that is loaded into the internal memory.
• The program number will flash in the PROGRAM No.
display (2).
• "---" will appear at the time of shipment from the
factory. (For checking feed home position)
2. Depress the foot switch to the 2nd step.
(If using a two-pedal foot switch, lower the work clamp
before depressing the start switch.)
• The feed mechanism will move to the home position
and the program number will be accepted.
• The program number will stop flashing and illuminate
steadily.
NOTE:
After completing the setting, be sure to refer to "5-6.
Checking the sewing pattern" to check that the needle
drop position is correct.
4954Q
2nd step
4457Q4421Q
4453Q
4498Q