Filter
Top Products
18
User Phone & Pendant
6 Connect the power cable
Plug the power cable into the socket on the
underside of your BT In Touch 2000 User
Phone as shown. The cable needs to be pressed
into its channel to keep it out of the way. The
way you do this will depend on how you have
positioned your phone (with or without the base
stand, wall-mounted or not). See ‘Desk and wall-
mounted phone positions’ on page 90.
Please note
The BT In Touch 2000 User Phone has 3 voice
prompts to indicate that mains power or the
telephone line has been disconnected or that the
battery power is low. These are:
“Telephone line disconnected”
“No mains power”
“Please change batteries”
You may hear these voice prompts when first setting
up your phone. This is perfectly normal and shows
the phone’s warning alerts are working.
7 Uncoil the pendant receiver aerial
The pendant receiver aerial which hangs from
the back of your BT In Touch 2000 User Phone
needs to be uncoiled.
Important
Please do not tamper with the pendant receiver aerial.
8 Positioning your BT In Touch
2000 User Phone
Your BT In Touch 2000 User Phone can be
positioned in 3 different ways:
Please note
Make sure you test your phone before you finally fix
it in position.
• Flat on a table or desk.
• Raised position on a table or desk using
the base stand.