Filter
Top Products
8
Verve 500 – New Style – Edition 3 – 07.09.06 – 7706
If you experience any problems, please call the Helpline on 0870 242 6652 or email bthelpdesk@convergys.com
Talk/Standby time
In ideal conditions, fully charged
handset batteries should give about
12 hours talk time or 120 hours
standby time on a single charge. The
base must remain plugged in to the
mains and switched on at all times.
Note that a new battery pack will not
reach full capacity until it has been in
normal use for several days.
Battery low warning
If the handset has 15 minutes or less
talk-time remaining the symbol
will flash in the display. If you are on a
call, you will hear 2 warning beeps
every 30 seconds to alert you. You
will need to recharge the handset
before you can use it again.
If the batt
ery is completely flat, it will
take several minutes to become active
again after being placed on the
charger. You will need to charge the
batt
eries for 12 hours before they are
fully charged.
Battery performance
To keep your battery pack in the best
condition, leave the handset off the
base for a few hoursat a time.
Running the battery right down at
least once a week will help it last as
long as possible.
Getting started
Insert the MT Li-ion 3.7V 600mAh rechargeable battery supplied
by plugging the small battery connector plug into the socket
inside the battery compartment. Make sure the battery wires are
tucked in and then slide the battery compartment cover back on.
3. Place the handset on the base to charge for at least 24 hours.
You will hear a beep and the handset display will come on
briefly to confirm the handset is sitting correctly.
4. After 24 hours, plug one end of the telephone line cord into
the socket on the back of the base and the other end into the
telephone wall socket.
Set the date and time
We recommend that you set the date and time (as shown
below) so they can be recorded with each answering machine
message you receive.
1. Press
Menu
to open the main menu. Then use the NAVIGATION
buttons to highlight the menu and press
OK
.