Filter
Top Products
CM/SIP IP Telephone Configuration Requirements
Issue 2 December 2007 47
Continue adding station
information for the SIP
phone using the Station
form (page 2)
add station xxxxxx
(where xxxxxx
represents the
extension number)
Bridged Call
Alerting
Set to "y" if the extension for
this SIP telephone will have a
"bridged" appearance defined
on another non-SIP
telephone. Note that no other
attributes of the bridged
appearance feature apply to
SIP telephones (e.g. off-hook
indication, bridge-on, etc.).
Restrict Last
Appearance
By default, the last call
appearance is reserved for
outgoing calls from a phone.
On stations with only three (3)
call appearances, set the field
to "n" for proper SIP
conference and transfer
operation. In this mode, all
call appearances are
available for making or
receiving calls.
AUDIX Name Enter the name of the voice
messaging system
administered for this system.
Coverage After
Forwarding
This field, with a default of "s"
for system, governs whether
an unanswered forwarded
call is given CM coverage
treatment.
Per Station CPN
Send Calling
Number?
If CM is configured to always
send Caller ID, you can
individually block certain
stations by setting this field to
"n". This field also needs to
be set to "n" if you want to
use the "Calling Number
nblock" FNE.
Continue adding station
button assignments for
the SIP telephone using
the Station form (page 4)
BUTTON
ASSIGNMENTS
1. call-appr
2. call-appr
etc.
Fill in the number of call
appearances ("call-appr"
buttons) to be supported for
this telephone. Use the
following guidelines to
determine the correct
number:
To support certain transfer
and conference scenarios,
the minimum number of
"call-appr" buttons should be
3.
Table 8: CM/SIP Configuration Requirements (continued)
Task/Form Command Field(s) Value(s)
3 of 4